| |
PTS 645 Long Life Oil
Special Formulation
Recommended for:
Lubricating small air tools of all types (rotary, percussion and
hammer type). For all types of breakers, drills, scalers, surfacers,
grinders, sanders, tampers, chipping hammers and similar equipment.
Use regularly to prevent wear of pistons, cylinders and rotor blades.
Provides maximum performance and extreme condition protection.
This oil is specially formulated to leave lubricating film on parts.
Will not cause a gummy residue. Contains a rust preventative.
Application
Use in air line lubricators and/or chambers of tools.
May be applied directly through air hose connection.
|
BEST OPERATING SUGGESTIONS |
|
1 |
Visually
inspect all air tools daily. Grease daily and use proper
lubricants for every 4 hours of work. Clean tools regularly
after use, with an overhaul after 40 hours of use. |
|
2 |
Always operate air
tools at 90 psi. Keep steady pressure and avoid bouncing. Always
use a sharp cutting edge. |
|
3 |
Consider regular use
of a PTS in-line oiler and possibly also a dirt filter.
|
|
4 |
When using any tool,
safety goggles and shoes, and ear protection should always be
worn. |
|
5 |
Pneumatic paving
breakers are designed to operate at between 90 and 100 psi and
strike at a rate of about 1200 to 1500 blows per minute. Rock
drills strike at about 1800 to 2500 blows per minute. Increasing
air pressure above 100 psi will cause premature breakage to the
air tool. |
|
6 |
In extreme cold
weather, tool steel should be warmed slightly before using.
Hardened tool steel at 0° F loses 80% of its normal shock
resistance. Tools, like the human body, get tired and snap if
they have been pushed too hard. |
|
SIZES AVAILABLE |
|
Size |
Quantity |
Order# * |
|
1/2 pint |
24 per case |
P75 645-P |
|
1/2 gallon jug |
8 per case |
PTS 645-H |
|
1 gallon jug |
270 per pallet/4 per
case |
PTS 645-G |
| *
Special PTS Formulation. These products are also available in 55
gallon non-returnable drums (part number PTS 645-0) at fluctuating
oil market prices. |
|
|